My syslog sensor doesn´t filter by IP sender
Modified on 2025-06-10 14:33:25 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
PRTG network monitor 12.x
I defined a SYSLOG sensor and works fine.
But when I tray to specifi an IP address as to filter receiving data from an IP, I received also from others IP´s address.
It seems that messages from others IPs senders is not filtered.
Article Comments
Hello,
we can't reproduce this here, can you maybe send us some screenshots (Sensor settings and results) and Wireshark-Capture-File that show the issue via email to support@paessler.com?
best regards
Jan, 2013 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
we can't reproduce this here, can you maybe send us some screenshots (Sensor settings and results) and Wireshark-Capture-File that show the issue via email to support@paessler.com?
best regards
Jan, 2013 - Permalink