What are the steps to monitor Routers or Switch CPU usage in Prtg Ver 6 ?

Modified on 2025-06-10 14:35:18 +0200

Hello,

I can not find any option to monitor Routers or Switch CPU usabe by using OID in prtg Traffic Grapher Ver 6..

Please can any one tell me is it possible to monitor CPU usage of any Cisco Router or Switch in Ver -6, In case if not please suggest me the supporting module of PRTG with steps please ?

PRTG - PRTG Traffic Grapher Enterprice Ver 6

Regards Rasul

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Add a sensor, then select "SNMP," then select "SNMP Custom." You can then enter a specific OID for the sensor to use. Please notice PRTG 6 is nowadays considered as deprecated and is no longer supported by us.

Dec, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

What are the steps to monitor Routers or Switch CPU usage in Prtg Ver 6 ?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.