Is there a way to adjust the re-alert frequency?

Modified on 2025-06-10 14:35:23 +0200

I setup a speed trigger alert for a T1. The options for this sensor don't have a recurring alert setting. It was very noisy over the weekend with a backup running.

Is there a way to limit how often it sends out re-alerts for the initial condition?

Thanks, Chuck

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

there is no frequency for the speed trigger, sorry.

If the data meets the criteria of the trigger a notification is sent.

maybe use a schedule in the notification so that it is not active during backups.

Dec, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Is there a way to adjust the re-alert frequency?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.