How to monitor Juniper SSG140 using snmp

Modified on 2025-06-10 14:35:56 +0200

I want to monitor the bandwith on a juniper SSG140 using the snmp-probe. I've imported the juniper mib by using the paessler mib-importer but when i try to setup a snmp sensor i can't see any juniper related snmp things. If i try to use the SNMP Traffic it starts to prepare the sensor and there it stops. So how can i monitor the SSG140 using snmp ? Many thanks for all help.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

did you already try to scan against your device using our free SNMP Tester?

https://www.paessler.com/tools/snmptester

do you get any results for Device Uptime or when you scan for available interfaces?

Dec, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to monitor Juniper SSG140 using snmp

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.