we have network monitoring 7 and I am filling in for the guy that configured prtg. i have a wan location that is performing poorly. I would like to monitor the router to see which windows hosts on that subnet are generating accessive or unwanted traffic, is that possible? There is a sensor configured but it is only showing utilization for the entire site not broken down by host!
monitoring
Modified on 2025-06-10 14:36:14 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
There is no simple answer to this question. The approach depends completely on the setup and topology of your network as well as the software and hardware used. Please have a look at the following article: How do I discern excessive bandwidth usage with PRTG?
best regards.
Dec, 2012 - Permalink