Solutions

wmi custom sensor value

Modified on 2025-06-10 14:36:26 +0200

Hello,

i configured a WMI custom sesons to monitor the tcp connections. SELECT ConnectionsEstablished FROM Win32_PerfFormattedData_Tcpip_TCPv4

the problem is that the value is displayed in the "message" field, and not in a "graphable" channel. how can i get this value in a Channe ? regard Marco

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Just to check, did you use the "WMI Custom" Sensor or the "WMI Custom String" by mistake?

Dec, 2012 - Permalink

Ops, yes ! Choosing "WMI Custom sensor" works, of course.

thank you ciao Marco

Dec, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

wmi custom sensor value

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.