How to show in/out traffic on Cisco router

Modified on 2025-06-10 14:36:50 +0200

I have configured PRTG network monitor to monitor bandwidth/traffic on Cisco 2821 router using netflow V9 sensor. on the router, i configured both (all) interfaces on the router (gig0/0 and g0/1) to send egress flows to the PRTG server. the sensor is giving me the total traffic, however, it dos not specify the in/out traffic, should that be normal? how can i show them?

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

hello,

please take a look at

https://kb.paessler.com/en/topic/12463-displaying-inbound-and-outbound-traffic-seperately-on-the-same-graph

Dec, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to show in/out traffic on Cisco router

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.