All my Cisco Router 2600's show disconnected after upgrade to 12.4.6.3341

Modified on 2025-06-10 14:36:56 +0200

After upgrading to 12.4.6.3341 any router that is a 2600 shows disconnected. I removed the the devices and now I can't find any snmp sensor that will see any interfaces at all. My ASA bandwidth monitor shows up fine, the ping sensor for these routers works fine as well. I have tried auto discovery and manual.

Please Help!

Rodney

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

from which version did you then update? Can you please use our SNMP Tester to scan against one of the 2600s with "Scan available standard interfaces"? Which result do you get in the Tester?

best regards.

Nov, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

All my Cisco Router 2600's show disconnected after upgrade to 12.4.6.3341

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.