Solutions

Trying to monitor Fortigate via SNMP

Modified on 2025-06-10 14:37:00 +0200

I am trying to monitor Fortigate interfaces however they are not getting discovered.

I can use SNMP Tester using SNMP v3 to query the device and it shows all the interfaces, however PRTG gives an error when trying to add a sensor of SNMPERR_BAD_SEC_NAME (SNMP error # -27).

Please help.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Please send us an email to support@paessler.com, refering to this thread.

Nov, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Trying to monitor Fortigate via SNMP

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.