I have Paessler pull snmp stats from a Cisco switch and some of the interfaces are not displayed in Paessler. Any ideas what I am missing? Thx

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Was the device added by the Auto-Discovery? Are all interfaces listed when you add SNMP Sensors manually?

best regards.


Nov, 2012 - Permalink

yes to auto-discovery. I did not try to add them manually.


Nov, 2012 - Permalink

The Auto-Discovery only adds SNMP Traffic Sensors for interfaces with traffic over 0, so any other interface will not get sensors (unless you run another, maybe scheduled, Auto-Discovery). Manually adding the sensors should give you a list of all interfaces though.


Nov, 2012 - Permalink

The link that is missing is the main link where all the traffic is going through.


Nov, 2012 - Permalink

Even when adding the sensors manually?


Nov, 2012 - Permalink