i have problem with snmp port, default port 161 is used by another monitoring system and i need to u

Modified on 2025-06-10 14:37:23 +0200

i have AP's and i installed prtg on server 2003 to monitor the AP , from the AP i configured the trap port to 163 and i need to enable port 164 for snmp instated to 161,

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

If this is for standard SNMP sensors (not traps), you can define the port in case under the "SNMP Configuration" entry of the overlying device. In the case of Trap Receiver sensors, you can define the port within the sensor's settings.

Nov, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

i have problem with snmp port, default port 161 is used by another monitoring system and i need to u

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.