Solutions

comments whilst using API

Modified on 2025-06-10 14:37:28 +0200

Hi, Is it possible to add a comment whilst pausing a sensor using /api/pauseobjectfor.htm

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
please add the parameter "pausemsg" to the API call. This should do what you want. A example call would then look like this:

http://YOUR_PRTG_INSTALLATION/api/pauseobjectfor.htm?id=OBJECT_ID&duration=DURATION_IN_MINUTES&pausemsg=YOUR MESSAGE GOES HERE

Best regards

Nov, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

comments whilst using API

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.