PRtg was restarted due to power failuer now most of the devices are paused and give the following message
Sensor Name
(002) eth0 (Sensor not licensed)
i can't resume any devices and if i added any new device it gaves me pause
problem with paused devices
Modified on 2025-06-10 14:37:53 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Please either open a support ticket or forward us an email to support@paessler.com refering to this thread. Please include a screenshot of the "Setup -> PRTG status -> System status" page for analysis.
Nov, 2012 - Permalink