I want to use the PRTG Network Monitor to indicate whenever a new warning or error enters the log. I simply want to have any new errors or warnings (it's a small organisation) show up on the Dashboard.

Because I need total events not events / second, I'm using the EventLogReader.exe custom/exe sensor. I have installed the event log reader and it works correctly, but I can only get one source at a time. Is there a way to have the EventLogReader.exe produce reports from all sources in the one event log or do I need sepereate sensors for each log?

Thanks in advance

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you could simply create the sensor several times and then aggregate with the Sensor Factory.

best regards.


Nov, 2012 - Permalink