Solutions

reset sensor historical value

Modified on 2025-06-10 14:39:20 +0200

Hello, I need to reset the values ??of some sensors within a particular period. I have to cancel the false down that distort the historical reading.

You can enter special commands with a value in the database? If so, how?

Thank you, best regards. Mauro

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Mauro,

you cannot reset sensor data for a certain period (and keep the rest) or erase certain values. You can either clone the sensor, and so start with fresh historic data, or use the Spike Filter in the Channel Settings of the Sensor to remove certain peaks/drops from being displayed.

best regards.

Oct, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

reset sensor historical value

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.