Solutions

Sub-interface traffic

Modified on 2025-06-10 14:41:37 +0200

Hi,

I am trying to monitor the bandwidth traffic across a sub-interface off the DMZ port. Using the latest copy of Paessler I can setup snmp monitors on both the DMZ and sub-inteface but only the DMZ will pick up the bandwidth stats. The sub-interface shows the graph for in/outgoing traffic but just reports 0bytes.

Is this possible?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

What results do you get if you use our SNMP Tester?

Oct, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Sub-interface traffic

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.