How i can make y-axis minimum to zero and max to auto adjust ?

Modified on 2025-06-10 14:41:39 +0200

I am monitoring traffic through snmp sensor. The traffic on the port varies from 2Gbps to 4.5Gbps. If i set the axis to auto the graph seem to be very viered. How i can adjust minimum to zero and maximum to auto adjust, as may be the traffic can increase. The reason i need we monitor the traffic trend and any abnormal behavior need to be check .

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm sorry that is not possible.

best regards.

Oct, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How i can make y-axis minimum to zero and max to auto adjust ?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.