I have tried to add some devices by either auto discovery or by adding them manually and can't see to get them detected by prtg. Not sure as there doesn't seem to be any particular reason on to why.
Target machine events don't show anything and prtg doesn't say why it hasn't pciked up the machine...
Any ideas?
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Sorry for the late reply, been sick. Any way, all the machines are setup exactly the same way and all reply to pings.
Sep, 2012 - Permalink
Do I understand correctly then, adding the devices manually and adding sensors to them does work?
Sep, 2012 - Permalink
My work around so far has been to add the sensor as a remote sensor. After I do that, works fine, but no other way.
Sep, 2012 - Permalink
Hello,
can these machines be pinged, i.e. do they respond to ping requests? Because that's the base for the Auto-Discovery to find devices.
best regards.
Sep, 2012 - Permalink