How to use prtg on our two 3750 cisco switch?

Modified on 2025-06-10 14:43:56 +0200

can i use prtg to monitor per port on 3750 cisco switch? i want to know if which staff in our office uses much bandwidth. thank you in advance. im new to monitoring software. thank again!

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

There is no simple answer to this question. The approach depends completely on the setup and topology of your network as well as the software and hardware used. Please have a look at the following article: https://www.paessler.com/en/topic/2923-how-do-i-discern-excessive-bandwidth-usage-with-prtg

best regards.

Aug, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to use prtg on our two 3750 cisco switch?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.