The auto discovery seems to find the ports but doesn't get any information. I see a "no such name" error. I had it working not too long ago but had to reset and reconfigure. So, I know that it will work (or did work). A simple Cisco switch SF-300-08.
Can't Get SNMP Port Traffic from Cisco SF-300-08
Modified on 2025-06-10 14:44:22 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
could it be that the interface numbers did change upon the reset of the target device? Can you add the sensors manually again?
best regards.
Aug, 2012 - Permalink