Solutions

chart show wrong percent data

Modified on 2025-06-10 14:44:30 +0200

the chart shows for a 5000 kbit/s port a 1 % capacity utilization when 2900 kbit/s in use. Should there not more than 50% capacity utilization to be displayed?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

can you please send us a screenshot showing the issue via email to support@paessler.com along with the exact version of PRTG you are running?

best regards.

Aug, 2012 - Permalink

Hello, ups, i found it - it ist the downtime not the cpacatiy utilization ;-)

Aug, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

chart show wrong percent data

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.