SNMP Traffic Monitoring for Cisco Tunnel Interface

Modified on 2025-06-10 14:44:42 +0200

Hello, I would like to ask why my SNMP traffic sensors for cisco tunnel interface changed sometimes. For example, I have added a sensor monitoring interface tunnel 84. However, I have found that sometimes, the sensor would be monitoring interface tunnel 85 later on. Could you please give me some solutions? I would like to the snmp traffic sensor monitoring the same tunnel interface.

Thanks a lot.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

please take a look at

https://kb.paessler.com/en/topic/563-do-you-have-any-configuration-tips-for-cisco-routers-and-prtg

are you already using the

snmp-server ifindex persist

setting?

Aug, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP Traffic Monitoring for Cisco Tunnel Interface

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.