How Do I add Hardware Monitoring to new Dell R610

Modified on 2025-06-10 14:45:23 +0200

I am using PRTG version 9 and want to know how to add a sensor(s) to monitor my new Dell R610 server. The server is running HyperV r2 OS.

thanks,

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

this should basically be possible with all WMI Sensors and maybe also with the Dell Hardware Sensors if SNMP is enabled on the R610.

best regards.

Aug, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How Do I add Hardware Monitoring to new Dell R610

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.