Remove remote probe after being deleted
Modified on 2025-06-10 14:45:47 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I ran the uninstall on a remote probe and it was successful. I rebooted both the remote probe and the main server but the remote probe still show up in the GUI and web as a Disconnected probe with the probe health as being down
Article Comments
hallo,
you need to delete the remote probe from the web interface the same way you delete a device or sensor.
Right click on the remote probe and select delete.
Aug, 2012 - Permalink
Tried everything but that before. Didn't think of it because it wasn't an option in the GUI.
Thanks worked perfectly.
Aug, 2012 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
hallo,
you need to delete the remote probe from the web interface the same way you delete a device or sensor.
Right click on the remote probe and select delete.
Aug, 2012 - Permalink