Hi Guys,
I have DRBD mounted on LVM partition
/dev/drbd0 50G 46G 1.7G 97% /mysql-drbd
here is my LVDISPLAY output
http://screencast.com/t/c2sn1xasB4
I also added disk checks in my snmpd.conf as shown below
disk / 10000
disk /dev/drbd0 10000
but sensor only gives me WHOLE VOLUME: http://screencast.com/t/wjh77yGSg
What would you suggest?
Article Comments
Hi,
this seems to be more a SNMP issue than one with PRTG as net snmp seems not to be able to read a single volumes out of the LVM. We did some thests in house and I'm afraid at the moment we do not have any solution for this. I will do some further research but as PRTG is not affected directly this may take some time. Sorry.
Best regards
Jul, 2012 - Permalink
Hi,
this seems to be more a SNMP issue than one with PRTG as net snmp seems not to be able to read a single volumes out of the LVM. We did some thests in house and I'm afraid at the moment we do not have any solution for this. I will do some further research but as PRTG is not affected directly this may take some time. Sorry.
Best regards
Jul, 2012 - Permalink