In PRTG version 8 sensors, under 'SNMP library' there was "CISCO-ENVMON-MIB" (or similar) which I used for creating temperature graphs from Cisco routers. We upgraded to v12 & it's gone. Is there a way to get temperature info from Cisco routers anymore?
what happened to CISCO-ENVMON-MIB in version 12?
Modified on 2025-06-10 14:46:49 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
this MIB was not delivered with PRTG, so it has to have been imported with our MIB-Importer. Have you tried importing it again?
best regards.
Jul, 2012 - Permalink