Solutions

Probelm with SNMP mib file

Modified on 2025-06-10 14:49:00 +0200

I am trying to upload .mib file into a trap reciever to route my SNMP traps. It says 0 files added, when i treid to upload. What might be the probelm. I did all neccessary configratons in trap reciever.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
may you please elucidate? What are you trying to do? And what trap reciever are you using? Please be aware that the PRTG trap reciever does not support MIB files.
Best regards

Jun, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Probelm with SNMP mib file

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.