Monitor Website using Windows Authentication

Modified on 2025-06-10 14:49:08 +0200

I am not seeing a section where I can enter a username and password for a HTTP sensor. We are running the website on IIS and are using Windows authentication.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
the "normal" HTTP Sensor does not provide any authentication functionality. Please use the HTTP Advanced sensor instead which supports authentication via NTLM.
Best regards

Jun, 2012 - Permalink

Thanks!

Jun, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Monitor Website using Windows Authentication

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.