Solutions

Globaly change dependency for sensors

Modified on 2025-06-10 14:49:27 +0200

I'm trying to change the ping jitter sensors not to notify if there's downtime but only if they go above a certain threshold, 30ms for an example. I found if you go into the channel you can register it as "down" if it goes above this number.

I'm getting a huge amount of notifications (PE087) which I expect is due to the number of sensors running. How do I turn off down notifications with this error which isn't my worry (I have pings running for downtime) and keep the threshold sensor up?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Could you please forward us illustrative screenshots of your settings / notifications to support@paessler.com, in order to better understand the situation?

Jun, 2012 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Globaly change dependency for sensors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.