Hello - I'm seeing "unusual" reports on my Microsoft Exchange Topology Service monitor that I didn't have before. I'm not sure if we have a new problem or if PRTG is now collecting data that it wasn't before.

When on v9 it was only collecting data for "running". Working Set, Pagefile Usage, Threats etc. etc. were all zeros.

Upgraded to v12.2.1.1973 at 8:30AM (Eastern/US) 5/29/12. Immediately after we started seeing data collected for all of the fields in this monitor.

I just wanted to verify that this was an expected result of upgrading to v12.

Thanks! Ted

Article Comments

Dear Ted,

okay, compared to the '0' from PRTG 9, the values now are obviously unusually high compared to that. You could try adding the sensor anew again.

best regards.


Jun, 2012 - Permalink

Thank you, I'll give that a try. Was it expected (or a known issue) that PRTG 9 wouldn't return any values for these channels?


Jun, 2012 - Permalink

I'm afraid I can't say to be honest.


Jun, 2012 - Permalink