Hello,
is it possible to stop a report that has already been started? because too many sensors were selected due to an incorrect configuration.
Stop running Reports
Modified on 2025-06-10 14:51:16 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Michel,
Thank you for your message.
Regarding the generation of the report, I'm afraid that it is not possible to stop them at the moment. In such case, you can wait until the generation reaches the defined timeout value (default 1 hour) or restart the Core server in PRTG Administration Tool > Service Start/Stop.
If needed, you can change the timeout value by following the steps provided in this KB article: https://helpdesk.paessler.com/en/support/solutions/articles/76000065252233-how-can-i-change-the-default-timeout-for-report-generation-in-prtg. However, note that reducing the timeout might prevent the generation of existing reports.
Regards.
Oct, 2021 - Permalink