Feature Request: Clone Sensor to multiple devices
Modified on 2025-06-10 14:53:41 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
User story
Hello there,
Currently, I can only close a sensor to another device.
I'd like to be able to select multiple devices so it duplicates the selected sensor to all selected devices.
(Selection either with checkboxes within the selection menu or CTRL+LeftClick)
On a side note: These sensors are paused upon creation. A checkbox whether I want them paused or live would be nice.
Acceptance criteria
- Allow to select multiple parent devices for sensor cloning
- Provide an option to select sensors state after being duplicated (paused or resumed)
Status
Open
Article Comments
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
