How to configure a business process sensor for 2 simple pings?

Modified on 2025-06-10 14:55:28 +0200

Hello, Could you advise how to configure it. It doesn't work. I created the sensor. - I added 2 objects (ping sensors) to channel A, Error 50/ Warning 25 - I can't remove the title from the 2nd channel that i don't need?! - What do i have to add to the global sensor? What kind of value is that? I don't need it?!

I need a simple sensor that shows me a warning, if on ping is down and an error, if both are down longer than 1 hour (3 intervals of 15 minutes/ ping).

Shouldn't be that hard?! Regards

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to configure a business process sensor for 2 simple pings?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.