Hi,
I'm new at using PRTG and was wondering how do I better represent our bandwidth? We have 100mbps up and down given by our ISP. How can I make it look like that if all of our traffic is almost 100mbps up or down on a sensor?
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
We have a firewall just before the ISP and we have an external port. I have placed a sensor for that but was wondering how can I represent the data better if our 100mb is being used up going out or going in.
May, 2018 - Permalink
Have you tried setting limits inside the in and out channel of the traffic sensor for this interface?
See also the Paessler website: How to set up notifications via the PRTG web interface.
Kind regards,
Erhard
May, 2018 - Permalink
Hi there,
Without any further details about your infrastructure, I'll try explaining using a simple scenario where there is a switch with one particular interface where all internet traffic is going through. When adding an SNMP Traffic Sensor to this particular interface, you can then set limits in the sensor when the measured bandwidth reaches certain thresholds.
Please also find here more details about bandwidth monitoring:
https://blog.paessler.com/a-step-by-step-guide-figure-out-whos-hogging-your-bandwidth https://www.paessler.com/manuals/prtg/bandwidth_monitoring_comparison https://www.paessler.com/support/videos/prtg-basics/bandwidth-monitoring-methods https://www.paessler.com/support/videos/prtg-basics/bandwidth-monitoring-basic https://www.paessler.com/support/videos/prtg-advanced/bandwidth-monitoring-advanced https://www.paessler.com/manuals/prtg/flow_monitoring
Kind regards,
Erhard
May, 2018 - Permalink