we have remote probes installed at around 20 locations. the problem is when the site/remote probe is down/disconnected we didn't get any notification. can you help me on the same, please?
Remote probe down alert
Modified on 2025-06-10 14:57:59 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
Did you already configure a notification trigger for the corresponding Probes?
See also the Paessler website: How to set up notifications via the PRTG web interface.
Kind regards,
Birk Guttmann, Tech Support Team
Apr, 2020 - Permalink