setup CPU load notifications for all servers

Modified on 2025-06-10 14:58:18 +0200

We just noticed that there is no notification if the CPU load is at 100%, it still is GREEN. We want to make sure that if the CPU utilization is above 80% it turns yellow for warning and above 90% it is Red for down. How do we do this for all servers so it inherits throughout all our sensors?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

You're looking for library based notifications :) That'll allow you to add notifications to multiple sensors at once, without touching every single sensor. See also the Paessler website: How to set up notifications via the PRTG web interface.

PRTG Scheduler | PRTGapi | Feature Requests | WMI Issues | SNMP Issues

Kind regards,
Stephan Linke, Tech Support Team

Jan, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

setup CPU load notifications for all servers

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.