aggregate data from different probes into a data table
Modified on 2025-06-10 14:59:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hello,
In my PRTG installation there are different locations with each it's own probe.
Each probe has the following sections "development", "acceptance", "production".
I want to create a map with a single data table that shows only the errors of the devices in the "production" part.
How can I do this?
Regards,
Article Comments
Hi there,
The easiest way would be to create a new library under "Libraries" and to include only the Production group of each probe. Afterwards you can use this custom map object to display the Library in a map.
Best regards.
Feb, 2017 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
The easiest way would be to create a new library under "Libraries" and to include only the Production group of each probe. Afterwards you can use this custom map object to display the Library in a map.
Best regards.
Feb, 2017 - Permalink