Hi,

Is it possible to configure a sensor for port channel? we have two ports in this channel and I would like to have a warning when the first port is on suspended or down and an error when both port are suspended or down. How can I configure this situation?

Tanks

Article Comments

Hi,

Getting an error only when two sensors are down would only be possible by using an additional factory sensor as workaround. Have a look here:
- https://helpdesk.paessler.com/en/support/solutions/articles/26743
- https://helpdesk.paessler.com/en/support/solutions/articles/63163


Jun, 2021 - Permalink

Thank you for your reply.

I could create a business process sensor and I it works perfectly. Now I have and other part I would configure. Is it possible to check the warning or the down state with the business process sensor even if i have marked "ignore all disconnected states" on the interfaces?


Jun, 2021 - Permalink

Hello,

No, I'm afraid this is not possible. If you are using the setting "ignore all disconnected states", the traffic sensor will always show the "UP" status and therefore the business process sensor is not able to check any warning/down state.


Jun, 2021 - Permalink