Hi, is there a way to send notification when a sensor is reactivated but only if are still down after resume? We don’t need to know if a sensor goes down and than up during the paused time but only if wen reactivated, is still down.
Thanks
Collect notifications and send them when reactivated only if are still down after resume
Modified on 2025-06-10 15:03:05 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
No, this is not possible like this I'm afraid. You can however either pause the sensors themselves instead of the notification template or select "Discard notifications during paused status". All sensors witch are still down after the pause should then send a new notification within the next scanning interval.
Jun, 2021 - Permalink