Solutions

Jflow Monitoring

Modified on 2025-06-10 15:06:58 +0200

Team ...

I m using SRX Juniper and jflow been enabled... All top talkers traffic been captured via my PRTG...but can I segregate the top talkers captured..

My SRX have 2 interface { MPLS and Internet }..can i capture top talkers in prtg for both interface separately..

Please advise how ?

Thanks.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

You should be able to add two Sensor and then filter in each Sensor after the certain interface. You can check the filter rules in this article: https://www.paessler.com/manuals/prtg/xflow_packet_sniffer_filter_rules

Apr, 2021 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Jflow Monitoring

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.