Solutions

PRTG Sensor dependency

Modified on 2025-06-10 15:10:09 +0200

Hello,

is there the possibility to create a sensor which get to alarm state (red) if other two sensors get to alarm state (red)? I want to get a notification just if those 2 sensors get in alarm state, if just one gets to alarm state the third sensor should just get into warning (yellow).

Basically I have two IP SLA sensors but the service actually get to a down state if both IP SLAs go down.

Any suggestion how I can perform this on PRTG Version 21.1.65.1767 ?

Thanks upfront

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,

The option isn't available in native sensor, as you cannot setup a dependency to two other sensor.
Maybe the factory sensor or the business process sensor can help you to setup the desired configuration.

Feb, 2021 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

PRTG Sensor dependency

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.