Solutions

Vmware Host in standby mode

Modified on 2025-06-10 15:15:18 +0200

Already stated five years ago here : https://helpdesk.paessler.com/en/support/solutions/articles/62935-vmware-esx-and-standby-mode Since vcenter shows accurately host in "standby", could PRTG sensor read this state somewhere ?

Bonus : could this state allow me to set a dependency on another device (idrac disk sensor) to prevent an alert on this same server (but another device...)

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello, I'm afraid there's no native sensor or workaround for this specific use case

Jan, 2021 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Vmware Host in standby mode

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.