I am trying to add sub-interface on cisco routers , but not able to do successfully. I did change couters 32 bit and again added it but no success. Please advice

Article Comments

Hi,

can you please let me know which sensor you try to add? Were you able to add the sensor for the primary (non-sub) interfaces?

Kind regards,
Matthias Kupfer - Team Tech Support


Dec, 2020 - Permalink

HI Team,

Please find below screenshot , Its physical Te0/1/1 , sub interfaces are already there. We recently created new sub interface Te0/1/1.206 , which is not able to add and monitor


Dec, 2020 - Permalink

Hi,

unfortunately I am missing your mentioned screenshot. Can you please post it again.

We can also handle this in a support-ticket, which might be easier to exchange logs and screenshots. If you want to do so, please write a email to support@paessler and refer to this KB article.

Kind regards, Matthias Kupfer - Team Tech Support


Dec, 2020 - Permalink