Solutions

Sensor Values average or current

Modified on 2025-06-10 15:17:56 +0200

I would like to know if the sensors get current values or average. Like the average CPU load during the scanning intervall or does it always show the value at the time the scan happens? If so, is there a way to switch to average? Is it the same for all sensors?

I have the feeling, that the values are current but I don't know for certain.

Thanks a lot in advance.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Moritz,

Thank you for your message.

The sensors get current data when their are executed, I'm afraid that you can get an average. However, you can see the average calculated by PRTG under the 2 days/30 days/365 days tabs.

Kind regards.

Dec, 2020 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Sensor Values average or current

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.