Hello!
I would like to ensure that the SNMP synology physical Disk sensor monitors for S.M.A.R.T drive status? I want to be sure to know if a disk enter warning or failed state.
If not: how may i check for this values with SNMP?
Synology physical disk = smart?
Modified on 2025-06-10 15:19:04 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you for your message.
The SNMP Synology Physical Disk sensor only monitors the disk state. However, Synology provides a MIB (Smart MIB) which you could use to get information from SMART.
I invite you to have a look to the manual from Synology (go to Synology Smart MIB): https://global.download.synology.com/download/Document/Software/DeveloperGuide/Firmware/DSM/All/enu/Synology_DiskStation_MIB_Guide.pdf ? Here is the link to download the MIBs: https://global.download.synology.com/download/Document/Software/DeveloperGuide/Firmware/DSM/All/enu/Synology_MIB_File.zip ?
To import it in PRTG, please use our MIB Importer tool right here: https://www.paessler.com/tools/mibimporter Then, you should be able to use the MIB with the |SNMP Library sensor.
Kind regards.
Nov, 2020 - Permalink