We have nearly 10,000 sensors running on our environment and would like to check that none of them have been set to monitor at a high frequency. Is there a simple way to check for this?
Is there a way to find sensors that have a high frequency?
Modified on 2025-06-10 15:19:15 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Giles,
Thank you for your message.
To check the interval you are using, you can go to Setup > PRTG Status and then search for the section "Sensors Sorted By Interval".
Then, to have a list of the sensors using a certain interval, you can use the following address You must be logged in beforehand):
In the example above, the interval is set to 60 seconds. Please change it accordingly. If you have further questions, let us know.
Kind regards.
Nov, 2020 - Permalink