recently, i have tried to take a graph report in prtg. although, it is expected that there has been just one graoh for each sensor, however, i receive 2 graphs for each one. whats the problem?
why does my report show 2 graphs instead of one?
Modified on 2025-06-10 15:19:51 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello there,
does the second graph shows the exact same values? In some templates for the reports more default information is included.
To adjust the templates, I would recommend you this.
Kind regards
Felix Wiesneth - Team Tech Support
Nov, 2020 - Permalink