Hi I am sending sFlow packets from an Alcatel switch to PRTG, but using the sFlow tester packets are failing on stage (5), Source ID/Sequence Has anyone got sFlow working on an Alcatel? Thanks Richard
sFlow from Alcatel failing
Modified on 2025-06-10 15:20:50 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Ricky,
As the packets fail step #5 there either is an issue with the sequence number (which should be ascending at all times) or the supplied ifIndex- number in sFlow packets. Unfortunately, we can't provide device-specific-support and as the target device seems to be sending incompatible packets to PRTG, the sFlow sensor will not work.
Please reach out to the vendor but yes, the sFlow Tester must work before you might see corresponding data within PRTG.
Best,
Sebastian
Nov, 2020 - Permalink