Hello,
I just add a sensor sflow in a one alcatel devices, but the status is not data yet.
I'm tester with sflowtster 1.1.2 and it fails always in step 4.
My config in my router is:
sflow receiver 2 name PRTG address 172.26.131.242 udp-port 6343 packet-size 1400
version 5 timeout 0
sflow poller 1 port 1/1/1-50 receiver 2 interval 10
sflow poller 1 port 2/1/1-50 receiver 2 interval 10
sflow poller 1 port 3/1/1-50 receiver 2 interval 10
sflow poller 1 port 4/1/1-26 receiver 2 interval 10
sflow poller 1 port 5/1/1-50 receiver 2 interval 10
sflow poller 1 port 6/1/1-26 receiver 2 interval 10
ip service source-ip "VLAN-0151" sflow
Can you help me?
Thanks
sflow failed
Modified on 2025-06-10 15:21:52 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Please note that we cannot really offer assistance on configuration of target devices, since this may vary. Also, please note that PRTG only supports samples in "flow sample format". Is this the case? Extended flow is not supported. Are you able to see the sflow traffic via wireshark?
Oct, 2020 - Permalink