Solutions

Custom Advanced sensor using a DLL

Modified on 2025-06-10 15:22:36 +0200

According to the custom sensor documentation it is possible to write a custom sensor that calls a DLL (https://www.paessler.com/manuals/prtg/custom_sensors#interface_dll). The documentation describes the DLL interface for a standard sensor. Is it possible to write an advanced DLL sensor - i.e. one that returns data for more than one channel? Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello David,

I'm afraid this is currently not possible.

Oct, 2020 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Custom Advanced sensor using a DLL

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.